Not quite bodywork...tail light alignment?

Moderators: Regional Representative, Technical Advisor

Forum rules
Only fully subscribed club members may post in this section. Please keep these threads on topic.
Post Reply
User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Not quite bodywork...tail light alignment?

Post by bhm1712 » Thu Jun 05, 2014 8:42 pm

Hi Guys,

quick query regarding tail light alignment.....

My old set of tail lights were slightly misaligned when tightened up into place - this was visible due to the clear reverse light sections. The left hand tail unit appeared to be lower than the right hand side by probably around 5mm+

now with my "new" tails it has swapped over. The right hand tail unit is now sitting lower than the left. Can this alignment be adjusted?? i cant see any means of doing that as the studs which stick through into the boot are fixed and thats the only thing which can affect the height as far as i see it!
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

SUPERCHARGEDGTA

Re: Not quite bodywork...tail light alignment?

Post by SUPERCHARGEDGTA » Thu Jun 05, 2014 8:51 pm

file the holes out a bit?

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: Not quite bodywork...tail light alignment?

Post by bhm1712 » Thu Jun 05, 2014 9:02 pm

i can certainly try but the holes in the tail panel into the boot are only just large enough to allow the studs through!
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: Not quite bodywork...tail light alignment?

Post by bhm1712 » Thu Jun 05, 2014 9:04 pm

i have a feeling its something to do with the actual studs that are screwed into the back of the tail light units - maybe they are not quite straight.I could perhaps bend them a little. I have just never seen the issue on any other firebird or T/A 2nd gen
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

Post Reply

Who is online

Users browsing this forum: No registered users and 39 guests