died at junction, but fine now?
Moderators: Regional Representative, Technical Advisor
Forum rules
Only fully subscribed club members may post in this section. Please keep these threads on topic.
Only fully subscribed club members may post in this section. Please keep these threads on topic.
- montrose
- POC Jr. Poster
- Posts: 120
- Joined: Sun Jul 10, 2011 4:01 pm
- Membership No: 11 T248
- Year: 1995
- Model: Trans Am
- Engine: 350
- Name: Larry Willett
- Location: Montrose, Scotland
- Location: Montrose, Scotland
- Contact:
died at junction, but fine now?
1995 TA, LT1, started fine, warmed up, drove 1 mile and died when i stopped at junction. Turned key and pumped gas like crazy for about 10 tries. It started, and drove fine . did about 40 miles and parked it. Started right up next day and drove fine again. Any ideas why it would just die and then work ok?
- montrose
- POC Jr. Poster
- Posts: 120
- Joined: Sun Jul 10, 2011 4:01 pm
- Membership No: 11 T248
- Year: 1995
- Model: Trans Am
- Engine: 350
- Name: Larry Willett
- Location: Montrose, Scotland
- Location: Montrose, Scotland
- Contact:
Re: died at junction, but fine now?
Thanks John. Was thinking that, but I'm not too mechanical. Does it need replaced, or is it just all this rain .
Re: died at junction, but fine now?
hopefully it is a one off with all the rain, you could try spraying WD40 on it and keep your fingers crossed
Who is online
Users browsing this forum: No registered users and 38 guests