Will these work?

Moderators: Regional Representative, Technical Advisor

Forum rules
Only fully subscribed club members may post in this section. Please keep these threads on topic.
Post Reply
User avatar
bigbadbob
POC Newbie
Posts: 92
Joined: Mon Oct 31, 2011 2:11 pm
Year: 1980
Model: Trans Am
Engine: 406
Name: Rob
Location: Maidenhead
Location: Maidenhead
Contact:

Will these work?

Post by bigbadbob » Thu Jan 30, 2014 1:43 pm

Much that I'd love a set of the year one deep dish rally IIs, I haven't that sort of money. But I've got a set of 5 spoke revolution alloys which came as spares with my car when I bought it - I was told they should fit my 1980 Trans am. Stud pattern looks about right.

Using a ruler they measure 16" across the front face (inner face seems slightly smaller?) edge to edge.
Width edge to edge looks just about 8 and 3/4".

Does that make them 15" or 16" rims? and 8.5" or 9" width?

I've no idea how to measure if the offset (distance from hub to outer rim?) is correct. Anyone know?

Also, if I was to use these apart from needing a bit of a refurb, I'd need to get some of those long revolution wheel nuts - so what length, width, thread would I need to look for?

Or... should I just flog them and stick to the snowflakes?
Image

SUPERCHARGEDGTA

Re: Will these work?

Post by SUPERCHARGEDGTA » Thu Jan 30, 2014 3:59 pm

it is the inside edge, where the tyre bead rests that you measure to give tyre diameter
as for offsets and pattern Im sure Jon will be on later and will know the correct offset etc.

liveseywhu
POC Newbie
Posts: 44
Joined: Mon Mar 30, 2009 4:31 pm
Year: 1972
Model: trans am
Engine: 455
Location: essex
Contact:

Re: Will these work?

Post by liveseywhu » Thu Jan 30, 2014 11:59 pm

they sound like 15x8 , to measure the back space put a straight edge across the inner face and then measure how deep it is to the hub.
i run that size with a 4" back space all round

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: Will these work?

Post by bhm1712 » Sun Feb 02, 2014 11:12 pm

for reference, the sticky topic on this subforum by firebreather has the PCD and other wheel info for most Pontiacs...
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: Will these work?

Post by bhm1712 » Sun Feb 02, 2014 11:12 pm

Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest