lack of fuel

Moderators: Regional Representative, Technical Advisor

Forum rules
Only fully subscribed club members may post in this section. Please keep these threads on topic.
Post Reply
Chief ThunderCloud
POC Newbie
Posts: 5
Joined: Tue Jul 30, 2013 11:26 pm
Year: 1964
Model: Star Chief
Engine: 389
Name: Jim Matthews
Contact:

lack of fuel

Post by Chief ThunderCloud » Wed Aug 21, 2013 12:40 am

Hi there.
I've got a 64 Star Chief with 389 motor which i'm havin probs gettin petrol to.
Petrol comes out the tank when i pull pipe off and the front to back pipe is clear.
I've had the pump apart and all seems ok - main diaphrams not perished and valve diaphrams seem ok too... but its not pumping! >:(
any ideas???

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: lack of fuel

Post by bhm1712 » Wed Aug 21, 2013 7:11 am

fuel pump push rod broken? or push rod actuator lobe worn down so much that its not pushing the push rod so to speak?

remove the pump and check the push rod. I checked mine whilst i had the pump off a few weeks ago by pressing it into its channel, and got my dad to turn the engine over with a spanner at the crank pulley. I verified that the rod moved up and down a decent distance.
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

Chief ThunderCloud
POC Newbie
Posts: 5
Joined: Tue Jul 30, 2013 11:26 pm
Year: 1964
Model: Star Chief
Engine: 389
Name: Jim Matthews
Contact:

Re: lack of fuel

Post by Chief ThunderCloud » Wed Aug 21, 2013 12:24 pm

not sure if it push rod or lobe but engine done 61000 - would that be enough to wear the lobe?
if it is a worn lobe, how easy/difficult to replace - will i be able to find a replacement?
thanx ian

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: lack of fuel

Post by bhm1712 » Wed Aug 21, 2013 5:33 pm

If the lobe is worn its a new cam shaft. 61000 is low but it depends how the engine has been maintained. It needs checking to verify it before you go down the replacement route.
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

SUPERCHARGEDGTA

Re: lack of fuel

Post by SUPERCHARGEDGTA » Wed Aug 21, 2013 9:13 pm

did you try operating the pump manualy while it was off?

Chief ThunderCloud
POC Newbie
Posts: 5
Joined: Tue Jul 30, 2013 11:26 pm
Year: 1964
Model: Star Chief
Engine: 389
Name: Jim Matthews
Contact:

Re: lack of fuel

Post by Chief ThunderCloud » Thu Aug 22, 2013 1:15 pm

SUPERCHARGEDGTA wrote:did you try operating the pump manualy while it was off?
Yeah, main diaphram went up n down nicely an very little wear on the actuating arm. So popped it back on but narfink!!!
....hope it not a worn lobe - sounds like a big job :(
I can feel an electric fuel pump comin to the party....

SUPERCHARGEDGTA

Re: lack of fuel

Post by SUPERCHARGEDGTA » Thu Aug 22, 2013 2:06 pm

did it suck/blow if you put your finger over the pipes?

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: lack of fuel

Post by bhm1712 » Thu Aug 22, 2013 2:22 pm

I'm currently investigating electric pumps and have drawn up an electrical circuit including safety cut out so give us a shout if you find out that you need it.

I would take the pump off again and test it as John has suggested - see if it sucks/blows.
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: lack of fuel

Post by bhm1712 » Thu Aug 22, 2013 2:23 pm

I notice you say the fuel runs out the tank if you take the pipe off and the pipe is clear - does fuel run out if you disconnect the pipe at the pump inlet then? I'm assuming it does.
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

Chief ThunderCloud
POC Newbie
Posts: 5
Joined: Tue Jul 30, 2013 11:26 pm
Year: 1964
Model: Star Chief
Engine: 389
Name: Jim Matthews
Contact:

Re: lack of fuel

Post by Chief ThunderCloud » Sat Aug 24, 2013 1:06 am

Yeah, think i'll recheck the pump off the car - fuel did come out the pipe when i removed the pump and i also blew on air line down it just in case.
Your electrical circuit sounds interesting ian - keep me posted? :thumb:
What electric fuel pump would you advise to use?

Chief ThunderCloud
POC Newbie
Posts: 5
Joined: Tue Jul 30, 2013 11:26 pm
Year: 1964
Model: Star Chief
Engine: 389
Name: Jim Matthews
Contact:

Re: lack of fuel

Post by Chief ThunderCloud » Sat Aug 24, 2013 1:22 am

I just thought, if i split the pump on the car i should be able to see if the diaphram is moving.... if it is then maybe it the one of the valves thats at fault, can these be replaced as i knocked one out unintentionally or more the point are they still available?????

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: lack of fuel

Post by bhm1712 » Sat Aug 24, 2013 2:44 pm

I'm not sure if I'm going to need an electric pump yet so I've not looked into which one.

The mechanical pumps are fairly easy to get hold of but not sure about the individual parts inside.
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest