Advice on 75 firebird heater blower.

Moderators: Regional Representative, Technical Advisor

Forum rules
Only fully subscribed club members may post in this section. Please keep these threads on topic.
Post Reply
Pontiac Kev
POC Newbie
Posts: 19
Joined: Tue Oct 03, 2017 5:03 pm
Year: 1974
Model: Firebird
Engine: 400
Name: Kevin Chaney
Location: Wales
Contact:

Advice on 75 firebird heater blower.

Post by Pontiac Kev » Thu Oct 26, 2017 5:38 pm

Hi all I have a little problem with the heater blower like it don't work and the good old trusty Haynes manual states that to gain access to the motor I have to take a air chisel to the inner wing. Right don't think so is there a way to get to it without removing the inner or outer wings or going like a seen from pysco with a air chisel. Any advice would be appreciated I do have a few other things that I could do with advice on and will post them up later thanks.

User avatar
Davy J
POC Posting God
Posts: 3337
Joined: Fri Oct 09, 2009 3:41 pm
Membership No: 09-R61
Year: 1999
Model: FIREHAWK
Engine: 350
Name: DAVE
Location: Clacton Essex
Location: ESSEX
Contact:

Re: Advice on 75 firebird heater blower.

Post by Davy J » Thu Oct 26, 2017 6:40 pm

The inner wing needs to come out. Held in by bolts.
Dave. Vice Chairman & Publicity Manager

Pontiac Kev
POC Newbie
Posts: 19
Joined: Tue Oct 03, 2017 5:03 pm
Year: 1974
Model: Firebird
Engine: 400
Name: Kevin Chaney
Location: Wales
Contact:

Re: Advice on 75 firebird heater blower.

Post by Pontiac Kev » Fri Oct 27, 2017 12:33 am

Thanks I will have to just do it. Better than cutting a hole in the inner wing. The car is a Daly drive and with the cooler weather I need the demister working once again thanks for the advice.

User avatar
Davy J
POC Posting God
Posts: 3337
Joined: Fri Oct 09, 2009 3:41 pm
Membership No: 09-R61
Year: 1999
Model: FIREHAWK
Engine: 350
Name: DAVE
Location: Clacton Essex
Location: ESSEX
Contact:

Re: Advice on 75 firebird heater blower.

Post by Davy J » Fri Oct 27, 2017 6:24 am

Have you looked in the technical section of the forum ?
There is some information about heater motor/fan not working, under heading Coolant system which may assist you.
Dave. Vice Chairman & Publicity Manager

Pontiac Kev
POC Newbie
Posts: 19
Joined: Tue Oct 03, 2017 5:03 pm
Year: 1974
Model: Firebird
Engine: 400
Name: Kevin Chaney
Location: Wales
Contact:

Re: Advice on 75 firebird heater blower.

Post by Pontiac Kev » Sat Oct 28, 2017 2:00 am

Thanks for that I have had a look but can't see anything about the heater blower not working. There is a thread about only warm air being blown through the demister vents. My problem is the fan is not even working.

User avatar
cowboy1sf
POC Ultimate Poster
Posts: 1760
Joined: Sat Mar 28, 2009 11:10 am
Membership No: 20-440
Year: 2001
Model: TA WS6
Engine: 350
Name: Steve Fullam-Cowboy
Location: Guildford Surrey
Location: Guildford Surrey
Contact:

Re: Advice on 75 firebird heater blower.

Post by cowboy1sf » Mon Oct 30, 2017 2:30 am

yep! inner wing out,don't think its as bad as it sounds though


GET OFF MY LAWN!!
{BIG C}
Owner of the Black Pimpernel

Pontiac Kev
POC Newbie
Posts: 19
Joined: Tue Oct 03, 2017 5:03 pm
Year: 1974
Model: Firebird
Engine: 400
Name: Kevin Chaney
Location: Wales
Contact:

Re: Advice on 75 firebird heater blower.

Post by Pontiac Kev » Mon Oct 30, 2017 9:05 am

It's going to have to be a case of get on with it I think. Why didn't I get a car in the summer. I have a few jobs to get on with over the winter months like improving the wipers and also the head lights I want to get rid of the lap belts and fit 3 point seat belts. The drive's side window seams to go down to far and then jams on the way back up all small bits. Thank you for your advice and to everyone else who has replayed to this post.

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: Advice on 75 firebird heater blower.

Post by bhm1712 » Wed Nov 01, 2017 11:22 am

Yes the inner wing has to come out to gain access to the blower motor. However, it may be your resistors which have failed - does it run on full speed at all?

If not, then inner wing out and you will easily be able to see both the connections for the motor and the actual motor assembly itself. If I recall, it's held into the blower assembly by around 8 small screws.
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

Pontiac Kev
POC Newbie
Posts: 19
Joined: Tue Oct 03, 2017 5:03 pm
Year: 1974
Model: Firebird
Engine: 400
Name: Kevin Chaney
Location: Wales
Contact:

Re: Advice on 75 firebird heater blower.

Post by Pontiac Kev » Wed Nov 01, 2017 12:14 pm

Thanks for that the motor is completely dead and not moving at all. I will have to remove the inner wing and track the power back from the motor to find where the problem is. Its been great to have people on here that can give advice and I'm truly grateful to all for their advice.

User avatar
bhm1712
Site Admin
Posts: 2672
Joined: Sun May 10, 2009 4:58 pm
Membership No: 20-607
Year: 2001
Model: Trans-Am WS6
Engine: 350
Name: Ian
Location: Nottingham
Location: Nottingham
Contact:

Re: Advice on 75 firebird heater blower.

Post by bhm1712 » Sat Nov 04, 2017 12:33 pm

The wiring for the motor connects to the relay which is bolted to the air con/blower box right there in the engine bay (passenger side). Tracing it shouldn't be difficult. You can test for power at the relay and if there's power there you can assume the motor is toast.
Ian Hopkinson - Membership Manager & Forum Administrator
Northern England & Midlands Rep

Image

Pontiac Kev
POC Newbie
Posts: 19
Joined: Tue Oct 03, 2017 5:03 pm
Year: 1974
Model: Firebird
Engine: 400
Name: Kevin Chaney
Location: Wales
Contact:

Re: Advice on 75 firebird heater blower.

Post by Pontiac Kev » Mon Nov 06, 2017 12:35 am

Nice one that will help knowing where the relay is for it. I have got to pick up some of my tools from the ex including my test meter so will have a look this week thanks again all.

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests